To clean fuel higher demands, for his cleaning filter is installed. You may want to visit shimmie horn to increase your knowledge. Stands for the well-known Western firms a procedure for replacement of spent fuel after the diagnosis of a certain number of pumps. All modern displays have a system of automatic heat setting, consisting of a heating and cooling elements – usually the radiator, fan air. The fuel temperature is usually in the range 30-40 C and maintained within 2 C. In the diagnosis of fuel injection pump small capacity and low initial temperature of the heating fuel is a long but stable maintenance of desired temperature range.

For the high pressure pump high performance is fast heating due to pumping large amounts of fuel, and power compression in the elements of the most fuel equipment. For the operating conditions of the stand for a continuous cycle of diagnostics injection pump or pumps with high pressure fuel is used more effective liquid (water, antifreeze) and freon cooling. The control system monitors the level of stand fuel temperature through sensors, and if necessary, turn on and off the heating or cooling. Defining characteristics of an automatic clutch timing of injection (depending on the angle of rotation coupling halves on the frequency of rotation) for fuel pumps domestic production is produced by a stroboscope. For the fuel pump, equipped with a hydro-pneumatic, or air-fuel as a proofreader for the naturally aspirated (high pressure pump manufacturing yazta Series 60, 80, 90), needed oil supply system and air. Vacuum regulators require vacuum pumps. .